Fagor CNC 8060 - Page 174

Operating manual.
CNC 8060
CNC 8065
8.
EDISIMU MODE (EDITING AND SIMULATION)
Working in the editing window.
·174·
(REF: 1807)
Graphic assistance for programming.
While editing the program, this window shows the 2D geometry of the program or of the profile
being edited. See
"8.5 Graphic assistance for the program editor." on page 185.
Template.
This option activates the use of the template for new programs. The "Edit template" button
opens a template at the editor to edit it. Only one template may be in the editor, called
"Template.nc" and must be saved in the following folder.
..\Users\Session\Templates
The "Save always" option of the editor sets how the template is saved, automatically or from
the softkey menu.
TEACH-IN parameters.
This option sets the behavior of each axis in TEACH-IN mode. Each axis may have one of
the following behaviors.
Autonumbering.
This option activates the auto-numbering of blocks and may be used to set the number of
the first block and the sequencing step for two consecutive blocks. While auto-numbering
is active, the CNC inserts the block number automatically every time a new block is generated
(line break).
ISO Translator.
Configuration table for the translator into the Fagor language from programs written in other
languages. To work with programs in the Fagor language, it is not required for the table to
be configured. Consult the "Translator of part programs" (man_8060_8065_pptrans.pdf)
manual for the available languages and the table meaning.
Behavior. Meaning.
Selected and visible. The axis is displayed in the TEACH-IN window and it is included in
the blocks being edited by pressing the [RECALL] key.
Not selected and visible. The axis is displayed in the TEACH-IN window, but it is not included
in the blocks being edited by pressing the [RECALL] key.
Not selected and hidden. The axis is neither displayed in the TEACH-IN window nor included
in the blocks being edited by pressing the [RECALL] key.