Operating manual.
CNC 8060
CNC 8065
PLC
20.
Program editing
·347·
(REF: 1807)
Program editor, Unicode format.
The editor of the CNC admits Unicode characters. When saving a program, the editor
respects its original format, ANSI or Unicode, except when editing a Unicode character, in
which case the CNC will always save the program in Unicode format.
Functionalities of the editor.
Zoom at the editor.
The editor has the following hotkeys to increase or decrease the size of the editor font. If
the CNC has a mouse with a wheel, the [CTRL] key combined with this wheel can also be
used to increase and decrease the size of the text font.
Multi-line blocks.
Softkey menu
When accessing the PLC program editor, the horizontal softkey menu will show all the
options associated with editing a file depending on the editing language.
Programs in Unicode format are not compatible with versions older than V4.0. A program in Unicode
format cannot be edited or executed in a version older than V4.0.
A third-party text editor (like Windows notepad) may be used to convert Unicode format programs into
ANSI format; but special characters that have no ANSI equivalent will be lost in the process.
[CTRL]+[+] Zoom in.
[CTRL]+[–] Zoom out.
The editor adjusts the long blocks to the size of the window dividing the block
into several lines. On the right side of each cut line, the editor shows a symbol
to indicate that the block continues in the next line.
To Next Page
Loading...
