Operating manual.
CNC 8060
CNC 8065
20.
PLC
"Logic analyzer" service
·368·
(REF: 1807)
While the graphic window is selected, use the "+" and "-" keys to divide or multiply this time
base by two.
Start distance / Trigger distance
This data is only shown when there is a trace.
The value is updated when moving the indicator cursor of the graphic area. Its value may
also be edited, thus updating the cursor position in the graphic area.
Reference distance
This data is only shown when there is a trace already and the operator has put a reference
signal. It represents the time difference between the indicator cursor and the reference
signal.
The value is updated when moving the indicator cursor of the graphic area. Its value may
also be edited, thus updating the cursor position in the graphic area.
Trace status
This element cannot be edited, it automatically reflects the status of the trace. The possible
messages are:
•Empty.
• Beginning.
• Executing.
•Stopping.
• Full.
With a time base of 10ms, 20ms and 4ms it will look like this.
Start distance It represents the time difference between the indicator cursor and the
base point of the trace (beginning of the trace if there is no trigger point
or it has not been reached).
Trigger distance It represents the time difference between the indicator cursor and the
trigger point (if it has taken place).
To Next Page
Loading...
