Fujitsu Eternus web GUI - Page 26

Chapter 2 Startup and Shutdown
2.1 Startup of GUI
ETERNUS Web GUI User’s Guide
26
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
End of procedure
• When using SSL (https), the "SSL Server Certificate" or the "Self-
signed SSL Certificate" must be registered in the ETERNUS DX
Disk storage system in advance. To obtain the "SSL Server
Certificate", send the CSR (downloaded using the procedure in
"11.2.3.16 Create Key/CSR" (page 492)
to the certification
authority. Register the obtained "SSL Server Certificate" by using
the procedure in "11.2.3.17 Register SSL Certificate" (page 497)
.
To obtain the "Self-signed SSL Certificate", use the procedure in
"11.2.3.15 Create Self-signed SSL Certificate" (page 490)
and
register the created "Self-signed SSL Certificate" in the
ETERNUS DX Disk storage system. Refer to "Appendix D
Installing the Security Certificate" (page 622) for details on how to
register the "Self-signed SSL Certificate".
• If Firefox 3.6.x is used for connecting to the ETERNUS DX Disk
storage system via "https", a communication error may occur.
This error can be avoided by connecting via "http" or by using
"Internet Explorer".
• Refer to "11.2.3.1 Setup Network Environment" (page 458) for
procedure to set the IP address of the MNT port.
• The default number of port that is used for http connection is "80".