Fujitsu Eternus web GUI - Page 485

Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
485
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
2 Specify the parameters, and click the [Set] button.
● Notification E-Mail
• Notification E-Mail
Select whether to "Enable" or "Disable" the E-Mail notification function.
• Destination E-Mail Address
Specify the E-Mail destination address.
At least one address must be specified. Up to five addresses can be specified.
The following input condition applies:
- Up to 63 alphanumeric characters and symbols (except spaces)
• Comment
Input the message (comment) to be added to the E-Mail. The comment can be omitted.
The following input conditions apply:
- Up to 225 characters
- Within ten lines
- Alphanumeric characters, symbols, and spaces
● Mail Server Settings
• LAN Port used for SMTP Connection
Select the LAN port connecting to the SMTP server from "MNT" or "RMT".
• Sender E-Mail Address
Input the E-Mail address of the ETERNUS DX Disk storage system.
The following input conditions apply:
- Up to 63 characters
- Alphanumeric characters and symbols (except spaces)
• SMTP Server
Specify the IP address or domain name of the SMTP server to be used.
The following input conditions apply:
- Up to 63 characters
- Alphanumeric characters and symbols
• SNMP Port No.
Specify the port number used by the SMTP server between 1 - 65535.
• SMTP requires authentication
Select the user authorization method to connect to the SMTP server from "None" or
"AUTH SMTP".
• User Name
If "AUTH SMTP" is selected for "SMTP Authentication Information", specify the sender
user name.
The following input conditions apply:
- Up to 32 characters
- Alphanumeric characters and symbols
• Password
When "AUTH SMTP" is selected for "SMTP Authentication Information", specify the
sender password.
The following input conditions apply:
- Up to 64 characters
- Alphanumeric characters and symbols