© 2011 Fujitsu Technology Solutions
347
9.6.1.2 Stack MAC Config
Figure : Stack MAC Config
Selection Criteria
Admin Mode - Select enable or disable from the pull down menu. When you select 'enable', the
Stack MAC Persistent Timer function will be enabled.
Configurable Data
Persistent Timer(Minutes) - Set the time period in minutes before the stack MAC address changes
to that of the new stack master. The valid range is from 0 to 60.
Command Buttons
Apply - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
i
Stack MAC persistency timer value of 0 means that, after a master switchover, the current
stack-mac will continue to be used indefinitely.
If the entire stack reloads, it comes up with the MAC address of the current stack master as the
stack MAC address.
To Next Page
Loading...
