© 2011 Fujitsu Technology Solutions
128
9.2.8 SNMP
9.2.8.1 Community Config
By default, two SNMP Communities exist:
• private, with 'Read/Write' privileges and status set to enable
• public, with 'Read Only' privileges and status set to enable
These are well-known communities, you can use this menu to change the defaults or to add other
communities. Only the communities that you define using this menu will have access to the switch using
the SNMPv1 and SNMPv2c protocols. Only those communities with read-write level access will have
access to this menu via SNMP.
You should use this menu when you are using the SNMPv1 and SNMPv2c protocol: if you want to use
SNMP v3 you should use the User Accounts menu or SNMP User Config menu.
Figure : SNMP Community Config
Selection Criteria
Community - You can use this screen to reconfigure an existing community, or to create a new one.
Use this pull down menu to select one of the existing community names, or select 'Create' to add a
new one.
Protocol - Select IPv4 or IPv6 to configure the corresponding attributes.
Access Mode - Specify the access level for this community by selecting Read/Write or Read Only
from the pull down menu.
Status - Specify the status of this community by selecting Enable or Disable from the pull down
menu. If you select enable, the Community Name must be unique among all valid Community
Names or the set request will be rejected. If you select disable, the Community Name will become
invalid.
To Next Page
Loading...
