Fujitsu PRIMERGY BX900 - CDP Commands

© 2011 Fujitsu Technology Solutions
569
10.6.15 CDP Commands
10.6.15.1 show cdp
This command displays the CDP configuration information.
Syntax
show cdp
Default Setting
None
Command Mode
Privileged Exec
Display Message
CDP Admin Mode: CDP enable or disable.
CDP Hold Time (sec): The length of time a receiving device should hold the L2 Network Switch CDP
information before discarding it.
CDP Transmit Interval (sec): A period of the L2 Network Switch to send CDP packet.
Port: Port number vs CDP status.
CDP: CDP enable or disable.
10.6.15.2 show cdp neighbors
This command displays the CDP neighbor information.
Syntax
show cdp neighbors
Default Setting
None
Command Mode
Privileged Exec
Display Message
Device Id: Identifies the device name in the form of a character string.
Local Interface: The CDP neighbor information receiving port.
Holdtime: The length of time a receiving device should hold CDP information before discarding it.
Capability: Describes the device's functional capability in the form of a device type, for example, a
switch.