© 2011 Fujitsu Technology Solutions
10
1 Important Notes
Store this manual close to the device. If you pass the device on to third parties, you should pass this
manual on with it. Be sure to read this page carefully and note the information before you open the
device. You cannot access the switch blade without first opening the device. Please observe the safety
information provided in the “Important Notes” chapter in this user’s guide. Components can become very
hot during operation. Ensure you do not touch components when handling the device. There is a danger
of burns! The warranty is invalidated if the device is damaged during the installation.
1.1 Information About Boards
To prevent damage to the device or the components and conductors on it, please take great care when
you insert or remove it. Take great care to ensure that the board is slotted in straight, without damaging
components or conductors on it, or any other components. Be especially careful with the locking
mechanisms (catches, centering pins etc.) when you replace the board.
Never use sharp objects (screwdrivers) for leverage. Boards with electrostatic sensitive devices (ESD)
are identifiable by the label shown. When you handle boards fitted with ESDs, you must, under all
circumstances, observe the following points:
− You must always discharge static build up (e.g., by touching a grounded object) before working.
− The equipment and tools you use must be free of static charges.
− Remove the power plug from the mains supply before inserting or removing boards containing
ESDs.
− Always hold boards with ESDs by their edges.
− Never touch pins or conductors on boards fitted with ESDs.
To Next Page
Loading...
