© 2011 Fujitsu Technology Solutions
103
9.2.5 User Management
9.2.5.1 User Accounts
By default, two user accounts exist:
• admin, with 'Read/Write' privileges
• guest, with 'Read Only' privileges
By default, password of admin user is “admin” and guest’s is blank. The names are not case sensitive.
If you logon with a user account with 'Read/Write' privileges (i.e. as admin) you can use the User
Accounts screen to assign passwords and set security parameters for the default accounts, and to add
and delete accounts (other than admin) up to the maximum of six.
Figure : User Accounts Config
Selection Criteria
User - You can use this screen to reconfigure an existing account, or to create a new one. Use this
pull down menu to select one of the existing accounts, or select 'Create' to add a new one, provided
the maximum of five 'Read Only' accounts has not been reached.
Authentication Protocol - Specify the SNMPv3 Authentication Protocol setting for the selected user
account. The valid Authentication Protocols are None, MD5 or SHA. If you select None, the user will
be unable to access the SNMP data from an SNMP browser. If you select MD5 or SHA, the user
login password will be used as the SNMPv3 authentication password, and you must therefore
specify a password, and it must be eight characters long.
Encryption Protocol - Specify the SNMPv3 Encryption Protocol setting for the selected user
account. The valid Encryption Protocols are None or DES. If you select the DES Protocol you must
enter a key in the Encryption Key field. If None is specified for the Protocol, the Encryption Key is
ignored.
To Next Page
Loading...
