© 2011 Fujitsu Technology Solutions
317
9.4.9 Secure HTTP
9.4.9.1 Config
Figure : Secure HTTP Config
Configurable Data
Admin Mode - This select field is used to Enable or Disable the Administrative Mode of Secure
HTTP. The currently configured value is shown when the web page is displayed. The default value is
Disable.
TLS Version 1 - This select field is used to Enable or Disable Transport Layer Security Version 1.0.
The currently configured value is shown when the web page is displayed. The default value is
Enable.
SSL Version 3 - This select field is used to Enable or Disable Secure Sockets Layer Version 3.0.
The currently configured value is shown when the web page is displayed. The default value is
Enable.
HTTPS Port Number - This field is used to set the HTTPS Port Number. The value must be in the
range of 1 to 65535. Port 443 is the default value. The currently configured value is shown when the
web page is displayed.
HTTPS Session Soft Timeout - This field is used to set the inactivity timeout for HTTPS sessions.
The value must be in the range of (1 to 60) minutes. The default value is 5 minutes. The currently
configured value is shown when the web page is displayed.
HTTPS Session Hard Timeout - This field is used to set the hard timeout for HTTPS sessions. This
timeout is unaffected by the activity level of the session. The value must be in the range of (1 to 168)
hours. The default value is 24 hours. The currently configured value is shown when the web page is
displayed.
Maximum Number of HTTPS Sessions - This field is used to set the maximum allowable number
of HTTPS sessions. The value must be in the range of (0 to 16). The default value is 16. The
currently configured value is shown when the web page is displayed.
Command Buttons
To Next Page
Loading...
