© 2011 Fujitsu Technology Solutions
263
9.3.21 Link State
!
This function is only provided on Switch mode.
9.3.21.1 Config
Figure : Link State Config
Selection Criteria
Admin Mode - Choose the link state administrative mode for the switch by selecting enable or
disable from the pull-down menu. The factory default is disabled.
Group ID – You can use this screen to reconfigure an existing group or to create a new one. Use this
pull-down menu to select one of the existing groups or select 'Create' to add a new one.
Group Mode - Choose the group administrative mode for the switch by selecting enable or disable
from the pull-down menu. The factory default is disabled.
Upstream - Choose the upstream port for a group. Switch will monitor the link level of this port for
rapidly fail-over of redundant LAN ports.
Configurable Data
Downstream - Choose downstream ports for a group. Switch will associate these downstream ports
with upstream port. If the upstream port is link down, all downstream ports will be disabled.
Otherwise, they will be enabled.
Command Buttons
Apply - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
To Next Page
Loading...
