Fujitsu PRIMERGY BX900 - 10.10.2 Configuration Commands

© 2011 Fujitsu Technology Solutions
651
10.10.2 Configuration Commands
10.10.2.1 spanning-tree
This command sets the spanning-tree operational mode to be enabled.
Syntax
spanning-tree
no spanning-tree
no - This command sets the spanning-tree operational mode to be disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
Default Setting
Disabled
Command Mode
Global Config
10.10.2.2 spanning-tree protocol-migration
This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
Syntax
spanning-tree protocol-migration {<slot/port> | all}
<slot/port> - is the desired interface number.
all - All interfaces.
Default Setting
None
Command Mode
Global Config