© 2011 Fujitsu Technology Solutions
11
1.2 Compliance Statements
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a “Class A” digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference-Causing
Equipment Regulations. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in strict accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between equipment and the receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
− Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Technology Solutions is not responsible for any radio or television interference caused by
unauthorized modifications of this equipment or the substitution or attachment of connecting cables and
equipment other than those specified by Fujitsu Technology Solutions. The correction of interferences
caused by such unauthorized modification, substitution or attachment will be the responsibility of the
user.
You may use unshielded twisted-pair (UTP) cables for RJ-45 connections – Category 3 or greater for 10
Mbps connections, Category 5 for 100 Mbps connections, and Category 5 or 5e for 1000 Mbps
connections.
!
Wear an anti-static wrist strap or take other suitable measures to prevent electrostatic
discharge when handling this equipment.
Industry Canada - Class A
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus
as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of the
Department of Communications.
Cet appareil numérique respecte les limites de bruits radioélectriques appli- cables aux appareils
numériques de Classe A prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques,”
NMB-003 édictée par le ministère des Communications.
To Next Page
Loading...
