© 2011 Fujitsu Technology Solutions
715
10.16.4 Radius Configuration Commands
10.16.4.1 radius accounting mode
This command is used to enable the RADIUS accounting function.
Syntax
radius accounting mode
no radius accounting mode
no - This command is used to set the RADIUS accounting function to the default value - that is, the
RADIUS accounting function is disabled.
Default Setting
Disabled
Command Mode
Global Config
10.16.4.2 radius-server host
This command is used to configure the RADIUS authentication and accounting server.
If the 'auth' token is used, the command configures the IPv4/IPv6 address or HostName to use to connect
to a RADIUS authentication server. Up to 3 servers can be configured per RADIUS client. If the maximum
number of configured servers is reached, the command will fail until one of the servers is removed by
executing the no form of the command. If the optional <port> parameter is used, the command will
configure the UDP port number to use to connect to the configured RADIUS server. In order to configure
the UDP port number, the IP address must match that of a previously configured RADIUS authentication
server. The port number must lie between 1 - 65535, with 1812 being the default value.
If the 'acct' token is used, the command configures the IPv4/IPv6 address or HostName to use for the
RADIUS accounting server. Only a single accounting server can be configured. If an accounting server is
currently configured, it must be removed from the configuration using the no form of the command before
this command succeeds. If the optional <port> parameter is used, the command will configure the UDP
port to use to connect to the RADIUS accounting server. The IPv4/IPv6 address or HostName specified
must match that of a previously configured accounting server. If a port is already configured for the
accounting server then the new port will replace the previously configured value. The port must be a value
in the range 1 - 65535, with 1813 being the default value.
Syntax
radius-server host {acct | auth} < ipAddr|ipv6Addr|hostname> [port]
no radius-server host {acct | auth} < ipAddr|ipv6Addr|hostname>
<ipAddr|ipv6Addr|hostname> - is a IPv4/IPv6 Address or Host Name.
[port] - Port number (Range: 1 – 65535)
To Next Page
Loading...
