© 2011 Fujitsu Technology Solutions
191
9.3.3 VLAN
9.3.3.1 Config
Figure : VLAN Config
Selection Criteria
VLAN ID and Name - You can use this screen to reconfigure an existing VLAN, or to create a new
one. Use this pull down menu to select one of the existing VLANs, or select 'Create' to add a new
one.
Participation - Use this field to specify whether a port will participate in this VLAN. The factory
default is 'Autodetect'. The possible values are:
• Include - This port is always a member of this VLAN. This is equivalent to registration fixed in
the IEEE 802.1Q standard.
• Exclude - This port is never a member of this VLAN. This is equivalent to registration
forbidden in the IEEE 802.1Q standard.
• Autodetect - Specifies that port may be dynamically registered in this VLAN via GVRP. The
port will not participate in this VLAN unless it receives a GVRP request. This is equivalent to
registration normal in the IEEE 802.1Q standard.
Tagging - Select the tagging behavior for this port in this VLAN. The factory default is 'Untagged'.
The possible values are:
• Tagged - all frames transmitted for this VLAN will be tagged.
• Untagged - all frames transmitted for this VLAN will be untagged.
To Next Page
Loading...
