© 2011 Fujitsu Technology Solutions
362
10.4 Device Configuration Commands
10.4.1 Interface
10.4.1.1 show interface status
This command displays the Port monitoring information for the system.
Syntax
show interface status {<slot/port> | all}
<slot/port> - is the desired interface number.
all - This parameter displays information for all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Intf: The physical slot and physical port.
Type: If not blank, this field indicates that this port is a special type of port. The possible values are:
Source - This port is a monitoring port.
PC Mbr - This port is a member of a port-channel (LAG).
Dest - This port is a probe port.
Admin Mode: Selects the Port control administration state. The port must be enabled in order for it
to be allowed into the network. – It may be enabled or disabled. The factory default is enabled.
E-Keying Status: Indicates the E-Keying Status.
Physical Mode: Selects the desired port speed and duplex mode. If auto-negotiation support is
selected, then the duplex mode and speed will be set from the auto-negotiation process. Note that
the port's maximum capability (full duplex -100M) will be advertised. Otherwise, this object will
determine the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status: Indicates the port speed and duplex mode.
Link Status: Indicates whether the Link is up or down.
Link Trap: This object determines whether to send a trap when link status changes. The factory
default is enabled.
LACP Mode: Displays whether LACP is enabled or disabled on this port.
Flow Mode: Displays flow control mode.
Capabilities Status: Displays interface capabilities.
To Next Page
Loading...
