Fujitsu PRIMERGY BX900 - Configuration Commands

© 2011 Fujitsu Technology Solutions
794
10.20.2 Configuration Commands
10.20.2.1 Configure priority of a switch
This command uses to configure the priority of a switch. Switch has higher priority will have a better
chance to become stack master in a stack system.
Syntax
switch <unit> priority <0-15>
no switch <unit> priority
<unit> - unit number of a switch which is range from 1 to 8.
<0-15> - priority value is range from 0 to 15.
no - This command resets the priority value to unassigned.
Default Setting
Unassigned
Command Mode
Global Config
10.20.2.2 switch provision
This command uses to configure a new switch. User can pre-configure this switch before the physical
switch is joined to the stack system.
Syntax
switch <unit> provision [<name>]
no switch <unit> provision
<unit> - unit number of a switch which is range from 1 to 8.
<name> - name of a provisional switch.
no - This command remove the configuration of this switch.
Default Setting
None
Command Mode
Global Config