Fujitsu PRIMERGY BX900 - Page 797

© 2011 Fujitsu Technology Solutions
795
10.20.2.3 Moving management control from one switch to another
This command is used to move the management switch from one to another.
Syntax
switch movemanagement <fromunit> <tounit>
<fromunit> - unit number of a switch which is range from 1 to 8.
<tounit> - unit number of a switch which is range from 1 to 8.
Default Setting
None
Command Mode
Global Config
10.20.2.4 Configuring a standby switch
This command is used to configure a standby switch for a stack.
Syntax
switch standby <unit>
<unit> - unit number of a switch which is range from 1 to 8.
Default Setting
None
Command Mode
Global Config