© 2011 Fujitsu Technology Solutions
148
9.2.10 CDP
9.2.10.1 Config
Use this menu to configure the parameters for CDP, which is used to discovery CISCO device in the
LAN.
Figure : CDP Config
Selection Criteria
Admin Mode - CDP administrate mode which are Enable and Disable.
Port State - the CDP administrate mode for all ports which are Enable and Disable.
Configurable Data
Hold Time - the legal time period of received CDP packet.
Transmit Interval - the CDP packet sending interval.
Non-Configurable Data
Slot/Port - Specifies the list of ports.
Command Buttons
Apply - Send the updated screen to the switch. Changes take effect on the switch but these
changes will not be retained across a power cycle unless a save is performed.
To Next Page
Loading...
