Fujitsu PRIMERGY BX900 - TACACS+ Configuration Commands

© 2011 Fujitsu Technology Solutions
719
10.16.5 TACACS+ Configuration Commands
10.16.5.1 tacacs host
This command is used to configure the TACACS server.
When this command executes, the Command Mode will change to TACACS mode to configure specified
values for the host.
Syntax
tacacs host <ipAddr|ipv6Addr|hostname>
no tacacs host <ipAddr|ipv6Addr|hostname>
<ipAddr|ipv6Addr|hostname> - is a IPv4/IPv6 address or Host Name.
no - This command is used to remove the configured TACACS server. The
<ipAddr|ipv6Addr|hostname> parameter must match the IPv4/IPv6 address or Host name of the
previously configured TACACS server.
Default Setting
None
Command Mode
Global Config
This command is used to configure specified authentication and encryption key of the TACACS server.
Syntax
key [<0/7> <key-value>]
If this command without any parameter, the key value will be removed and use global key
Note that the length of the secret key is up to 32 characters.
<0/7> - 0 specifies key in plain text and 7 specifies key in excrypted form.
<key-value> - TACACS authentication and encrypted key.
Default Setting
None
Command Mode
TACACS mode