Fujitsu PRIMERGY BX900 - Show Eventlog; Show Running-Config

© 2011 Fujitsu Technology Solutions
356
10.3.3 show eventlog
This command displays the event log, which contains error messages from the system. The event log
will not be cleared on a system reset.
Syntax
show eventlog
Default Setting
None
Command Mode
Privileged Exec
Display Message
File: The file in which the event originated.
Line: The line number of the event.
Task Id: The task ID of the event.
Code: The event code.
Time: The time this event occurred.
Note: Event log information is retained across a switch reset.
10.3.4 show running-config
This command is used to display/capture the current setting of different protocol packages supported on
switch. This command displays/captures only commands with settings/configurations with values that
differ from the default value. The output is displayed in script format, which can be used to configure
another switch with the same configuration.
When a script name is provided, the output is redirected to a configuration script. The option [all] will also
enable the display/capture of all commands with settings/configurations that include values that are
same as the default values. If the optional <scriptname> is provided with a file name extension of “.scr”,
the output will be redirected to a script file.
Syntax
show running-config [all] [<scriptname>] [|]
[all] - enable the display/capture of all commands with settings/configurations that include values
that are same as the default values.
[<scriptname>] - redirect the output to the file <scriptname>.
[|] - Output modifiers.