© 2011 Fujitsu Technology Solutions
55
5.6 Software Download
5.6.1 In Operation Code CLI
Software Download through TFTP/FTP Server
This section contains instructions for downloading device software through a TFTP/FTP server. The
TFTP/FTP server must be configured before beginning to download the software.
System Image Download
The device boots and runs when decompressing the system image from the flash memory area where a
copy of the system image is stored. When a new image is downloaded, it is saved in the other area
allocated for the other system image copy. On the next boot, the device will decompress and run the
currently active system image unless chosen otherwise.
To download a system image through the TFTP/FTP server:
1. Ensure that an IP address is configured on one of the device ports and pings can be sent to a
TFTP/FTP server.
2. Make sure that the file to be downloaded is saved on the TFTP/FTP server (the image file).
3. Enter (CB)#show version command to verify which software version is currently running on the
device. The following is an example of the information that appears:
(CB) #show version
Serial number :SQ823LW00114
Hardware Version :1.0
Number of ports :48
Label Revision Number :1
Part Number :A3C40096531
Machine Model :PY CB Eth Switch/IBP 1Gb 36/12
Loader version :0.7
Operation code version :0.40
Boot rom version :0.9
4. Enter (CB)#whichboot command to verify which system image is currently active. The following is
an example of the information that appears:
Boot-System....................... Switch
Next Booting Mode................. Switch
file name file type startup size (byte)
---------------------------------- ----------------------- ------- --------------
sb11a-b-0.9.0212.biz Boot-Rom image Y 373327
To Next Page
Loading...
