© 2011 Fujitsu Technology Solutions
246
9.3.18 Port Channel
9.3.18.1 Config
Figure : Port Channel Config
Selection Criteria
Port Channel Name – You can use this screen to reconfigure an existing Port Channel, or to create
a new one. Use this pull down menu to select one of the existing Port Channels, or select 'Create' to
add a new one. There can be a maximum of 64 Port Channels.
Link Trap - Specify whether you want to have a trap sent when link status changes. The factory
default is enable, which will cause the trap to be sent.
Administrative Mode - Select enable or disable from the pull down menu. When the Port Channel is
disabled no traffic will flow and LACPDUs will be dropped, but the links that form the Port Channel
will not be released. The factory default is enable.
Static Capability Mode - May be enabled or disabled by selecting the corresponding line on the pull
down entry field. The factory default is disabled. This field is non-configurable for read-only users.
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port Channel.
The possible values are:
• Disable - spanning tree is disabled for this Port Channel.
• Enable - spanning tree is enabled for this Port Channel.
Load Balance - Configure load balance mode for the interface port-channel. The possible values
are:
• Source MAC address - Sets the mode on the source MAC address.
To Next Page
Loading...
