Fujitsu PRIMERGY BX900 - Secure Shell (SSH) Commands

© 2011 Fujitsu Technology Solutions
548
10.6.9 Secure Shell (SSH) Commands
10.6.9.1 show ip ssh
This command displays the SSH settings.
Syntax
show ip ssh
Default Setting
None
Command Mode
Privileged Exec
Display Message
Administrative Mode: This field indicates whether the administrative mode of SSH is enabled or
disabled.
Protocol Levels: The protocol level may have the values of version 1, version 2, or both versions.
SSH Sessions Currently Active: This field specifies the current number of SSH connections.
Max SSH Sessions Allowed: The maximum number of inbound SSH sessions allowed on the
switch.
SSH Timeout: This field is the inactive timeout value for incoming SSH sessions to the switch.
10.6.9.2 ip ssh
This command is used to enable SSH.
Syntax
ip ssh
no ip ssh
no - This command is used to disable SSH.
Default Setting
Enabled
Command Mode
Global Config