Fujitsu PRIMERGY BX900 - IGMP Snooping Querier

© 2011 Fujitsu Technology Solutions
444
10.4.7 IGMP Snooping Querier
10.4.7.1 Show Commands
10.4.7.1.1 Display IGMP snooping querier global info
This command display IGMP snooping querier global information on the system.
Syntax
show ip igmp snooping querier
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
IGMP Snooping Querier Mode: Administrative mode for IGMP Snooping. The default is disable.
Querier Address: Specify the Snooping Querier Address to be used as source address in periodic
IGMP queries. This address is used when no address is configured on the VLAN on which query is
being sent
IGMP Version: Specify the IGMP protocol version used in periodic IGMP queries.
Querier Interval: Specify the time interval in seconds between periodic queries sent by the snooping
querier. The Query Interval must be a value in the range of 1 and 1800. The default value is 60
Querier Expiry Interval: Specify the time interval in seconds after which the last querier information
is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default
value is 60.