© 2011 Fujitsu Technology Solutions
513
10.6.3 Telnet Session Commands
10.6.3.1 telnet
This command establishes a new outbound telnet connection to a remote host.
Syntax
telnet <host> [port] [debug] [line] [echo]
<host> - A hostname or a valid IP address.
[port] - A valid decimal integer in the range of 0 to 65535, where the default value is 23.
[debug] - Display current enabled telnet options.
[line] - Set the outbound telnet operational mode as ‘linemode’, where by default, the operational
mode is ‘character mode’.
[echo] - Enable local echo.
Default Setting
None
Command Mode
User Exec, Privileged Exec
To Next Page
Loading...
