© 2011 Fujitsu Technology Solutions
345
9.6 Stacking Menu
i
Functions in this menu are only provided in stackable Ethernet Connection Blade.
9.6.1 Configuration
9.6.1.1 Unit Config
Figure : Stacking Unit Config
Selection Criteria
Switch ID - Displays the list of units of the stack. Details of the selected unit are displayed. There is
also a Create option visible only to Admin users which can be used to pre-configure new members of
the stack.
Standby Switch - Select a unit in the stack to be the Standby switch. The unit configured as the
Standby switch becomes the stack master if the current stack master fails. Select 'None' for auto
selection Standby switch by stack master.
Auto Upgrade - To enable or disable the auto upgrade feature on a switch. When a switch is wanted
to join a stack and its firmware version is lower than the stack master, then auto firmware upgrade
will be performed if this feature is enabled on the stack master.
Priority - A two-byte field that indicates whether the administrator wants this unit to become a
management unit in preference to another unit. The default value for this setting is one. If the
preference level is set to zero then the device cannot become a management unit. This field is
non-configurable for users with read-only access.
Configurable Data
To Next Page
Loading...
