© 2011 Fujitsu Technology Solutions
349
9.6.2 Information
9.6.2.1 Summary
Figure : Stacking Summary
Non-Configurable Data
ID# - Displays the ID of the unit. The maximum number of units allowed in the stack is 8.
Name - Displays the identifier of the unit.
Role - This field indicates whether the unit is a stack master or stack member.
Standby Status - This field indicates the unit that is configured as the Standby unit.
• Oper Standby - Indicates that this unit is operating as the Standby Unit and the configured
Standby Unit is not part of the stack.
• Cfg Standby - Indicates that the unit is configured as the Standby Unit. The unit configured
as the Standby switch becomes the stack master if the current stack master fails.
• Blank - the switch is not configured as the Standby Unit.
MAC Address - The MAC address of switch units..
Priority - A two-byte field that indicates whether the administrator wants this unit to become a
management unit in preference to another unit. The default value for this setting is “Unassigned’’. If
the preference level is set to ‘'Disable'’ then the device cannot become a management unit. This field
is non-configurable for users with read-only access.
Current Status - This field indicates the unit status. There are eight possible state values:
• Ready
• Not Ready
• Unsupported
• CodeMismatch
• Mode Mismatch
• Code Updating
• NotPresent
Code Version - This field indicates the detected version of code on this unit.
Command Buttons
Refresh - Update the information on the page.
To Next Page
Loading...
