Fujitsu PRIMERGY BX900 - Dhcpv6 Client Commands

© 2011 Fujitsu Technology Solutions
552
10.6.11 DHCPv6 Client Commands
10.6.11.1 ipv6 address protocol
This command specifies the network of IPv6 configuration protocol to be used . If you modify this value,
the change is effective immediately.
Syntax
ipv6 address protocol {dhcp6 | none}
<dhcp6> - Obtains IP address from DHCPv6.
<none> - Obtains IP address by setting configuration.
Default Setting
None.
Command Mode
Interface-Vlan Config
10.6.11.2 ipv6 dhcp6 restart
This command is used to initiate a DHCPv6 client request by the network interface.
Syntax
ipv6 dhcp6 restart
Default Setting
None.
Command Mode
Global Config