Fujitsu PRIMERGY BX900 - Port

© 2011 Fujitsu Technology Solutions
183
9.3.2 Port
9.3.2.1 Config
Figure : Port Config
Selection Criteria
Classic View - Use pulldown menu to enable Classic View for port-identifiers. Example for Classic
View: enabled:"interface 1/0/1" | disabled:"interface BX900S1123456-CB1/0/1". When Unit/Slot/Port
is "All" and Classic View is changed, the other modifications will not be applied.
Unit/Slot/Port - Selects the interface for which data is to be displayed or configured.
STP Mode - Select the Spanning Tree Protocol Administrative Mode for the port or LAG. The
possible values are:
• Enable - select this to enable the Spanning Tree Protocol for this port.
• Disable - select this to disable the Spanning Tree Protocol for this port.