© 2011 Fujitsu Technology Solutions
184
Admin Mode - Use the pull down menu to select the Port control administration state. You must
select enable if you want the port to participate in the network. The factory default is enabled.
LACP Mode - Selects the Link Aggregation Control Protocol administration state. The mode must be
enabled in order for the port to participate in Link Aggregation. May be enabled or disabled by
selecting the corresponding line on the pull down entry field. The factory default is enabled.
Physical Mode - Use the pull down menu to select the port's speed and duplex mode. If you select
auto the duplex mode and speed will be set by the auto-negotiation process. Note that the port's
maximum capability (full duplex and 100 Mbps) will be advertised. Otherwise, your selection will
determine the port's duplex mode and transmission rate. The factory default is auto. The selection
when applied against the "All" option in Slot/Port is applied to all applicable interfaces only.
Link Trap - This object determines whether or not to send a trap when link status changes. The
factory default is enabled.
Flow Control - Used to enable or disable flow control feature on selected interface.
Broadcast Storm Control Mode - Used to enable or disable broadcast storm feature on selected
interface.
Broadcast Rate - Set the bit/packet rate value on selected interface. The valid values are from (1 to
4294967295).
Broadcast Unit Type - Set the rate Unit Type on selected interface. The possible values are:
• bps - bit per second.
• K bps - 1000(Kilo) bits per second
• M bps - 1,000,000(Mega) bits per second
• G bps - 1,000,000,000(Giga) bits per second
• pps - packet per second
• K pps - 1000(Kilo) packets per second
• M pps - 1,000,000(Mega) packets per second
• G pps - 1,000,000,000(Giga) packets per second
Example : If Broadcast Rate=128, Broadcast Unit Type=bps. It means the speed of the interface will
restrict to 128bps.
Multicast Storm Control Mode - Used to enable or disable multicast storm feature on selected
interface.
Multicast Rate - Set the bit/packet rate value on selected interface. The valid values are from (1 to
4294967295).
Multicast Unit Type - Set the rate Unit Type on selected interface. The possible values are:
• bps - bit per second.
• K bps - 1000(Kilo) bits per second
• M bps - 1,000,000(Mega) bits per second
• G bps - 1,000,000,000(Giga) bits per second
• pps - packet per second
• K pps - 1000(Kilo) packets per second
• M pps - 1,000,000(Mega) packets per second
• G pps - 1,000,000,000(Giga) packets per second
Example : If Multicast Rate=128, Multicast Unit Type=bps. It means the speed of the interface will
restrict to 128bps.
To Next Page
Loading...
