Fujitsu PRIMERGY BX900 - Page 187

© 2011 Fujitsu Technology Solutions
185
Unicast Storm Control Mode - Used to enable or disable unicast storm feature on selected
interface.
Unicast Rate - Set the bit/packet rate value on selected interface. The valid values are from (1 to
4294967295).
Unicast Unit Type - Set the rate Unit Type on selected interface. The possible values are:
• bps - bit per second.
• K bps - 1000(Kilo) bits per second
• M bps - 1,000,000(Mega) bits per second
• G bps - 1,000,000,000(Giga) bits per second
• pps - packet per second
• K pps - 1000(Kilo) packets per second
• M pps - 1,000,000(Mega) packets per second
• G pps - 1,000,000,000(Giga) packets per second
Example : If Unicast Rate=128, Unicast Unit Type=bps. It means the speed of the interface will
restrict to 128bps.
Storm Control Action Shutdown - Used to enable or disable to shutdown the selected interface
while the storm is detected.
Storm Control Action Trap - Used to enable or disable to send trap for the selected interface while
the storm is detected.
Configurable Data
Maximum Frame Size - The maximum Ethernet frame size the interface supports or is configured,
including Ethernet header, CRC, and payload. (1518 to 9216). The default maximum frame size is
1518 .
Capability - You could advertise the port capabilities of a given interface during auto-negotiation.
Port Description - Description string attached to a port. It can be of up to 64 characters in length.
Non-Configurable Data
Port Type - For normal ports this field will be blank. Otherwise the possible values are:
• Source - the port is a monitoring port. Look at the Port Monitoring screens for more
information.
• Destination - the port is a monitoring port. Look at the Port Monitoring screens for more
information.
• Port Channel - the port is a member of a Link Aggregation trunk. Look at the LAG screens for
more information.
E-Keying Status - Indicates the E-Keying Status.
Physical Status - Indicates the port speed and duplex mode.
Link Status - Indicates whether the Link is up or down.
ifIndex - The ifIndex of the interface table entry associated with this port.
Command Buttons