Fujitsu PRIMERGY BX900 - IGMP Snooping

© 2011 Fujitsu Technology Solutions
434
10.4.6 IGMP Snooping
10.4.6.1 Show Commands
10.4.6.1.1 show ip igmp snooping
This command displays IGMP Snooping information. Configured information is displayed whether or not
IGMP Snooping is enabled. Status information is only displayed when IGMP Snooping is enabled.
Syntax
show ip igmp snooping
Default Setting
None
Command Mode
Privileged Exec
Display Message
Admin Mode: This indicates whether or not IGMP Snooping is active on the switch.
Multicast Control Frame Count: This displays the number of multicast control frames that are
processed by the CPU.
Interfaces Enabled for IGMP Snooping: This is the list of interfaces on which IGMP Snooping is
enabled.
Vlan Enabled for IGMP Snooping: This is the list of interfaces on which IGMP Snooping is
enabled.
10.4.6.1.2 show ip igmp snooping mrouter
This command displays information on statically configured and dynamically learned multicast router
ports or multicast router configuration.
Syntax
show ip igmp snooping mrouter [ { vlan [slot/port] | interface [slot/port] } ]
slot/port - The interface number.
Default Setting
None
Command Mode
Privileged Exec