Fujitsu PRIMERGY BX900 - Page 435

© 2011 Fujitsu Technology Solutions
433
10.4.5.11 vtp trunkport
This command uses to configure the administrative domain trunk port for all of interfaces.
Syntax
vtp trunkport all
no vtp trunkport all
no - This command resets the administrative domain trunk port to default value.
Default Setting
Disabled
Command Mode
Global Config
This command uses to configure the administrative domain trunk port on specific interfaces.
Syntax
vtp trunkport
no vtp trunkport
no - This command resets the administrative domain trunk port to default value.
Default Setting
Disabled
Command Mode
Interface Config