© 2011 Fujitsu Technology Solutions
709
10.16.3 Dot1x Configuration Commands
10.16.3.1 dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid if the
control mode for the specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
Syntax
dot1x initialize <slot/port>
<slot/port> - is the desired interface number.
Default Setting
None
Command Mode
Privileged Exec
10.16.3.2 dot1x default-login
This command assigns the authentication login list to use for non-configured users for 802.1x port security.
This setting is over-ridden by the authentication login list assigned to a specific user if the user is
configured locally. If this value is not configured, users will be authenticated using local authentication
only.
Syntax
dot1x defaultl-login <listname>
<listname> - an authentication login list.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...
