Fujitsu PRIMERGY BX900 - Show Logging Traplog

© 2011 Fujitsu Technology Solutions
601
10.7.3 show logging traplog
This command displays the trap log maintained by the switch. The trap log contains a maximum of 256
entries that wrap.
Syntax
show logging traplogs
Default Setting
None
Command Mode
Privileged Exec
Display Message
Number of Traps since last reset: The number of traps that have occurred since the last reset of this
device.
Trap Log Capacity: The maximum number of traps that could be stored in the switch.
Log: The sequence number of this trap.
System Up Time: The relative time since the last reboot of the switch at which this trap occurred.
Trap: The relevant information of this trap.
!
Trap log information will not be retained across a switch reset.