Fujitsu PRIMERGY BX900 - Ipv6 Commands

© 2011 Fujitsu Technology Solutions
564
10.6.14 IPv6 Commands
10.6.14.1 show ipv6 interface
This command displays the switch’s IPv6 network configuration.
Syntax
show ipv6 interface
Default Setting
None.
Command Mode
User Exec, Privileged Exec
Display Message
IPv6 Address: The IPv6 address of the interface.
Address mode: The network configuration of the IPv6 protocol to be used. The factory default is
None.
10.6.14.2 show ipv6 traffic
Use this command to show traffic and statistics for IPv6 and ICMPv6. Specify a interface to view
information about traffic on a specific interface.
Syntax
show ipv6 traffic {oob | switchport}
Default Setting
None.
Command Mode
User Exec, Privileged Exec
Display Message
Total Datagrams Received: Total number of input datagrams received by the interface, including
those received in error.
Received Datagrams Locally Delivered: Total number of datagrams successfully delivered to IPv6
user-protocols (including ICMP). This counter increments at the interface to which these datagrams
were addressed, which might not necessarily be the input interface for some of the datagrams.
Received Datagrams Discarded Due To Header Errors: Number of input datagrams discarded due
to errors in their IPv6 headers, including version number mismatch, other format errors, hop count
exceeded, errors discovered in processing their IPv6 options, etc.