Fujitsu PRIMERGY BX900 - Configuration Commands

© 2011 Fujitsu Technology Solutions
775
10.18.2 Configuration Commands
10.18.2.1 mac access-list extended
This command creates a MAC Access Control List (ACL) identified by <name>, consisting of classification
fields defined for the Layer 2 header of an Ethernet frame. The <name> parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list. If a MAC ACL by this
name already exists, this command enters Mac-Access-List config mode to allow updating the existing
ACL.
Syntax
mac access-list extended <name>
no mac access-list extended <name>
<name> - It uniquely identifies the MAC access list.
Default Setting
None
Command Mode
Global Config
10.18.2.2 mac access-list extended
This command changes the name of a MAC Access Control List (ACL). The <name> parameter is the
name of an existing MAC ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1
to 31 characters uniquely identifying the MAC access list. This command fails if a MAC ACL by the name
<newname> already exists.
Syntax
mac access-list extended rename <name> <newname>
<name> - Old name which uniquely identifies the MAC access list.
<newname> - New name which uniquely identifies the MAC access list.
Default Setting
None
Command Mode
Global Config