Fujitsu PRIMERGY BX900 - Management Commands; Network Commands

© 2011 Fujitsu Technology Solutions
497
10.6 Management Commands
10.6.1 Network Commands
10.6.1.1 show ip interface
This command displays configuration settings associated with the switch's network interface. The
network interface is the logical interface used for in-band connectivity with the switch via any of the
switch's front panel ports. The configuration parameters associated with the switch's network interface
do not affect the configuration of the front panel ports through which traffic is switched or routed.
Syntax
show ip interface
Default Setting
None
Command Mode
User Exec, Privileged Exec
Display Message
IP address: The IP address of the interface. The factory default value is 0.0.0.0
netmask: The IP subnet mask for this interface. The factory default value is 0.0.0.0
VLAN: Specifies the management VLAN ID.
10.6.1.2 show ip redirects
This command displays IP default gateway for this switch.
Syntax
show ip redirects
Default Setting
None
Command Mode
User Exec, Privileged Exec
Display Message
IP default gateway: The default gateway for this IP interface. The factory default value is 0.0.0.0