Fujitsu PRIMERGY BX900 - Sflow Commands

© 2011 Fujitsu Technology Solutions
592
10.6.18 sFlow Commands
10.6.18.1 show sflow agent
The sFlow agent collects time-based sampling of network interface statistics and flow-based samples.
These are sent to the configured sFlow receivers. Use this command to display the sFlow agent
information.
Syntax
show sflow agent
Default Setting
None
Command Mode
Privileged Exec
Display Message
sFlow Version: Uniquely identifies the version and implementation of this MIB. The version string
must have the following structure: MIB Version; Organization; Software Revision where:
‧ MIB Version: ‘1.3’, the version of this MIB.
‧ Organization: Broadcom Corp.
‧ Revision: 3.0
IP Address: The IP address associated with this agent.