© 2011 Fujitsu Technology Solutions
591
10.6.17.15 lldp tx-delay
This command is used to set the timing parameters for data transmission delay on ports enabled for LLDP.
The <delay-seconds> determines the number of seconds to wait between transmitting local data
LLDPDUs. The range is 1-8192 seconds.
Syntax
lldp tx-delay <delay-seconds>
no lldp tx-delay
no - This command is used to return return the transmit delay to the default value.
Default Setting
2
Command Mode
Global Config
To Next Page
Loading...
