© 2011 Fujitsu Technology Solutions
792
10.20 Stacking Commands (SB11 in stacked mode only)
10.20.1 Show Commands
10.20.1.1 show switch
This command displays information of the stack members in the stack system. This command is only
available for Ethernet Connection Blade with stacking feature.
Syntax
show switch [<unit>]
Default Setting
None
Command Mode
Privileged Exec
Display Message
SW#: Displays the ID of the unit. The maximum number of units allowed in the stack is 8.
ID: Displays the identifier of the unit which is used to identify an interface on that switch.
Role: This field indicates whether the unit is a stack master or stack member.
• Mgmt Switch
• Stack Member
• Unassigned
Standby Status: Display the standby status of the switch.
• Oper Standby
• Cfg Standby
MAC Address: Displays the MAC address of the switch.
Priority: Displays the priority of the switch is range from 0 to 15, unassigned or disabled.
Current Status: Displays the status of the switch.
• Ready
• Not Ready
• Unsupported
• Code Mismatch
• Config Mismatch
• Not Present
• Code Updating
Version: This field indicates the detected version of code on this unit.
To Next Page
Loading...
