Fujitsu PRIMERGY BX900 - Page 555

© 2011 Fujitsu Technology Solutions
553
10.6.11.3 oob protocol
This command specifies the oob configuration protocol to be used. If you modify this value, the change is
effective immediately.
Syntax
oob protocol {bootp | dhcp | dhcp6 | none}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<dhcp6> - Obtains IPv6 address from DHCPv6.
<none> - Obtains IP address by setting configuration.
Default Setting
DHCP.
Command Mode
Global Config
10.6.11.4 oob protocol dhcp6 restart
This command is used to initiate a DHCPv6 client request by oob interface.
Syntax
oob protocol dhcp6 restart
Default Setting
None.
Command Mode
Global Config