© 2011 Fujitsu Technology Solutions
190
9.3.2.4 Error Disable Recovery
Figure : Port Error Disable Recovery
Selection Criteria
storm-control - Enables or disables the specify Error Disable Recovery Cause by storm-control.
The factory default is disabled.
udld - Enables or disables the specify Error Disable Recovery Cause by udld. The factory default is
disabled.
Configurable Data
Error Disable Recovery Interval - This Specifies the interval value for Error Disable Recovery. The
factory default is 300 seconds. The range of Interval is (30 to 86400) .
Non-Configurable Data
Interface - This Specifies the interface which is shutdown by Error Disable.
ErrDisable Reason - This Specifies the reason why this interface is shutdown.
Time Left (sec) - This Specifies the left time of this interface will be enabled.
Command Buttons
Apply - Update the IBP with the values on this screen. If you want the IBP to retain the new values
across a power cycle, you must perform a save.
Refresh - Refresh the data on the screen with the present state of the data in the IBP.
To Next Page
Loading...
