Fujitsu PRIMERGY BX900 - Page 523

© 2011 Fujitsu Technology Solutions
521
10.6.4.3 sshc maxsessions
This command specifies the maximum number of simultaneous outbound ssh sessions. A value of 0
indicates that no outbound ssh session can be established.
Syntax
sshc maxsession <0-5>
no sshc maxsession
<0-5> - max sessions (Range: 0 - 5).
no - This command sets the maximum value to be 5.
Default Setting
5
Command Mode
Global Config
10.6.4.4 sshc exec-timeout
This command sets the outbound ssh session timeout value in minute.
Syntax
sshc exec-timeout <1-160>
no sshc exec-timeout
<1-160> - max connect time (Range: 1 -160).
no - This command sets the remote connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default Setting
5
Command Mode
Global Config