Fujitsu PRIMERGY BX900 - Page 533

© 2011 Fujitsu Technology Solutions
531
10.6.5.11 snmp-server enable traps
This command enables the ACL trap.
Syntax
snmp-server enable traps acl-trapflags
no snmp-server enable traps acl-trapflags
no - This command disables the ACL trap.
Default Setting
Disabled
Command Mode
Global Config
This command enables the Authentication trap.
Syntax
snmp-server enable traps authentication
no snmp-server enable traps authentication
no - This command disables the Authentication trap.
Default Setting
Enabled
Command Mode
Global Config
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent only
if the Link Trap flag setting associated with the port is enabled (see 'snmp trap link-status' command).
Syntax
snmp-server enable traps linkmode
no snmp-server enable traps linkmode
no - This command disables Link Up/Down traps for the entire switch.