© 2011 Fujitsu Technology Solutions
585
10.6.17.7 show lldp local-device detail
This command uses to display detailed information about the LLDP data a specific interface transmits.
Syntax
show lldp local-device detail <slot/port>
<slot/port> - Displays a specific interface.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Identifies the interface that sends the LLDP frame.
Chassis ID Subtype: Shows the type of identification used in the Chassis ID field.
Chassis ID: Identifies the chassis of the local device.
Port ID Subtype: Identifies the type of port on the local device.
Port ID: Shows the port number that transmitted the LLDP frame.
System Name: Shows the system name of the local device.
System Description: Describes the local system by identifying the system name and versions of
hardware, operating system, and networking software supported in the device.
Port Description: Describes the port in an alpha-numeric format.
System Capabilities Supported: Indicates the primary function(s) of the device.
System Capabilities Enabled: Shows which of the supported system capabilities are enabled.
Management Address: Lists the type of address and the specific address the local LLDP agent uses
to send and receive information.
Management Address
• Management Address - Specifies the advertised management address of the remote system.
• Type - Specifies the type of the management address.
MAC/PHY Configuration/Status
• Auto-Negotiation - Specifies whether the auto-negotiation is supported and whether the
auto-negotiation is enabled.
• PMD Auto-Negoration Advertised Capabilities - Specifies the auto-negotiation and speed
capabilities of the PMD.
• Operational MAU Type - Specifies the current duplex and speed settings of the sending
system.
Power Via MDI
• MDI Power Support - Specifies the MDI power support capabilities of the sending IEEE 802.3
LAN station.
• PSE Power Pair - Specifies which pair is powered.
To Next Page
Loading...
