Fujitsu PRIMERGY BX900 - Page 590

© 2011 Fujitsu Technology Solutions
588
10.6.17.10 lldp receive
This command uses to enable the LLDP receive capability.
Syntax
lldp receive
no lldp receive
no - This command is used to return the reception of LLDP frames to the default value.
Default Setting
Disable
Command Mode
Interface Config
10.6.17.11 lldp transmit
This command uses to enable the LLDP advertise capability.
Syntax
lldp transmit
no lldp transmit
no - This command is used to return the local data transmission capability to the default.
Default Setting
Disable
Command Mode
Interface Config