Fujitsu PRIMERGY BX900 - Page 616

© 2011 Fujitsu Technology Solutions
614
10.9.1.5 clear config
This command resets the configuration to the factory defaults without powering off the switch. The switch
is automatically reset when this command is processed. You are prompted to confirm that the reset should
proceed.
Syntax
clear config
Default Setting
None
Command Mode
Privileged Exec
10.9.1.6 clear config interface
This command resets the interface configuration to the factory defaults without powering off the switch.
You are prompted to confirm that the reset should proceed.
Syntax
clear config interface <slot/port>
<slot/port> - is the desired interface number.
Default Setting
None
Command Mode
Privileged Exec